Attention of electric hoist

1. The European standard electric hoist should be operated by a special person. What is the European standard electric hoist? the operator should be allowed to master the safety operation procedures, and it is strictly forbidden to slant the crane.

2. The European standard electric hoist must be regularly inspected by specialized personnel during use. The unit price of the European standard electric hoist should be taken, and measures should be taken in time if any fault is found, and recorded carefully.

3. When adjusting the braking sliding amount of the European standard electric hoist, it should be ensured that under the rated load, the braking sliding amount s≦v/100 (v is the distance of stable lifting within one minute of the load).

4. Scrap standard of steel wire rope: The inspection and scrapping standard of steel wire rope shall be implemented in accordance with CB/T5972-1986 "Practical Specification for Inspection and Scrap of Steel Wire Rope for Hoisting Machinery".

5. The European standard electric hoist must keep enough lubricating oil and keep the lubricating oil clean, and should not contain impurities and dirt.

6. When oiling the wire rope, a hard brush or a small wooden piece should be used. It is strictly forbidden to oil the working wire rope directly by hand.

7. When the European standard electric hoist is not working, it is not allowed to hang it in the air at noon to prevent the parts from being deformed for a long time.

8. During use, if a fault is found, the main power supply should be cut off immediately.

The European standard electric hoist needs to be checked in time in the actual application process. If there is any problem, it can be solved in time. Let me introduce it to you below:

1. Check that the wear of the brake pad lining of the European standard electric hoist should not exceed 2mm, and the contact area between the lining and the brake wheel should not be less than 70%.

2. Check the installation and fixation of each pin and the wear and lubrication conditions. The wear of each pin should not exceed 5% of the original diameter, and the wear of the small shaft and mandrel should not exceed 5% of the original diameter and ovality. less than 0.5mm.

3. Check whether the wire rope has broken strands or serious wear, and whether the lubrication of the wire rope is good.

Attention of electric hoist

Post time: Feb-15-2022